Roof Safety Mesh Requirements

All mesh is to be lapped minimum of 150mm one square for purlins 2200 or greater to be lapped.

Roof safety mesh requirements.

9 installation requirements 9 1 general the installation of roof safety mesh shall comply with the requirements of clauses 9 2 and 9 3. If safety mesh is used ensure it. Safety mesh does not prevent falls from the edge of a roof or through unmeshed holes in a roof so. For purlin spacing 1200 2200 mm fasteners to be fitted at maximum of 900 mm centres and minimum single lap.

Each safety net must be equipped with a border rope for webbing that maintains a minimum breaking strength of 5 000 pounds. Appropriate lifting technique for long roof conforms to as nzs 4389 2015 roof safety mesh is installed by a competent person in a safe manner and in accordance with the manufacturer s instructions. Staging on the roof surface to spread the loads safety mesh secured under fragile roofing or skylights. For purlin spacing greater than 2200 mm fasteners to be fitted at maximum 600 mm centres and minimum double lap.

Therefore safety mesh always needs to be used with appropriate edge protection guardrails or fall arrest systems and devices. Regarding safety net openings osha requires all openings to not exceed 36 square inches nor six inches on any side. Safety mesh does not control the risk of falling from the perimeter or through penetration hazards. Longitudinal wire must face down with the cross wires facing up all longitudinal wires need to be wrapped around or through drilled holes in the purlins and tied off with a minimum of.